|
When FireAcad Disk is inserted, the
AutoPlay Dialog will pop up prompting to select run
setup.exe.
FireAcad trigger file path dialog will
appear telling where the facadtrigger folder default
location will be created. Leave the path as default and
press OK button to proceed.
FireAcad Conversion tool dialog will only
appear if the user is changing their USB MPI lock to a
USB 64 bit Lock.
Once you have successfully changed your
USB MPI lock to a USB 64 bit Lock, FireAcad Conversion
message will appear. Make sure to press OK and then Press
Exit button to proceed on.
This is the FireAcad main installation
dialog. Please choose REPAIR button on the bottom
right.
Files are being
transferred and at the same time, replacing your existing
files to the original files.
This dialog shows you have successfully
repaired FireAcad on your computer. You will then be able to
run FireAcad properly. |
